[nadhya]

Hi,

Did anybody knows about Myteck touchscreen HMI?
Can mitsubishi FX1N series intergrade with it..?
How bout the cable connector..?
Any idea?

Thanks.

[Johnson Lukose]

Hi,

Did anybody knows about Myteck touchscreen HMI?
Can mitsubishi FX1N series intergrade with it..?
How bout the cable connector..?
Any idea?

Thanks.

Hello Nadhya, I suppose you mean Mytek (http://www.mytek.com.my).

You did not mention the model / part #.

Hey, this is a Malaysian manufacturer! How difficult can it be to contact them? It's the cost of a local call!

At the very worst, drive to Puchong and bang on the door!!

The Mitsubishi FX1N comes with a serial interface for programming. I am not sure if the programming port can be utilized for HMI connections. Sometimes this can be done but only when using a Mitsubishi HMI as well.

You have to match the interface at the electronic level (RS232, RS485, Ethernet) and the protocol level (drivers, Modbus, TCP/IP), etc.

You have to match the Mitsubishi FX1N interface to Mytek interface (and drivers) with same port settings too.

The Mitsubishi FX1N has extension adapters and communication module options ranging from RS232, RS485, Profibus DP, DeviceNet, Ethernet, etc.

I don't think Mitsubishi FX1N have Modbus protocols.

It's only plug-n-play if its's Mitsubishi PLC + Mitsubishi HMI. Otherwise, you take on the technical responsibility to get it working together.

Enjoy the challenge.

thanks.

[Johnson Lukose]

Hi,

Did anybody knows about Myteck touchscreen HMI?
Can mitsubishi FX1N series intergrade with it..?
How bout the cable connector..?
Any idea?

Thanks.

Hello Nadhya, it looks like Mytek office is same with FA Controls;

Head Office:
FA Controls Sdn Bhd

No. 6, Jalan TPK 1/6 Seksyen 1,
Taman Perindustrian Kinrara,
47100 Puchong,
Selangor , MALAYSIA .

Tel : +60-3-8070 8866
Fax : +60-3-8070 8899

thanks.