Moore Industries’ Smart HART® Temperature Transmitters and Signal Isolators configure in minutes to accept a direct signal input from a wide array of
sensors and analog devices:

• 14 RTD Types
• 9 Thermocouple Types
• Current and Voltage Signals
• Resistance and Potentiometer Devices
• Direct Millivolt Sources

These 2-wire (loop-powered) transmitters provide an isolated and linear 4-20mA output proportional to the input. This signal is ready for direct interface with HART or non-HART based DCS, PLC and other computer-based SCADA systems.

Features
• Input-to-output analog accuracy of up to ±0.014°C (±0.025°F)* is the absolute best in the industry.
• 20-bit input resolution delivers exceptional digital accuracy of ±0.1°C (±0.18°F) with all Pt RTDs, or up to ±0.05°C (±0.09°F)* for Pt1000 RTD.
• Set up with HART Communicator, HART-based system, or PC (a HART modem is not needed for PC set up) allows you to check the status, or perform parameter changes, from the control room or any field termination point on the wires.
• FREE PC Configuration Software and Cable are provided with each order.
• Long-term stability provides up to 5 years between scheduled calibrations.
• Standard integral display on the model TDZ shows real-time process status and valuable loop diagnostic information.
• Advanced RFI/EMI protection and ambient temperature compensation guard against environmental factors that can quickly degrade measurement accuracy.

Courtesy of Moore Industries